3 Circuit SSG Circuit Board and parts.
3 MJL21194 Transistors, 3 Transistor insulator pads, 3 Neon bulbs, 3 4.7k ohm 1/2W resistors, 3 100 ohm 2W resistors, 3 3A 1000V diodes, 3 1A 1000V diodes, 3 stainless screw bolts with washers, 1 L angle aluminum heat sink with 3 drilled and tapped holes, 1 schematic. Does not include black terminal strip for resistors.
Transistor grease not included. Picture shows 6A diodes on board and the actual 3A diodes. Transistors and resistors also not exact shape and size.
These are the same parts used in all the big Monopole Energizer kits. Typically one of these goes with one of our 8 strand coils (which are usually either #18 or #23 gauge wire size), but can go with 2 or four of the same coils if the wires are doubled or quadrupled.
Use at your own risk. Using the circuits without a charging battery bank, with a fully charged battery bank, or an insufficient load will usually result in blowing of the transistors and diodes. Renaissance Charge will not accept returns on this product. Buyers are responsible to understand how to use these parts and check parts before and while using.
Resistor values may be changed for other values when multiple boards or higher voltages than 24V are used. The 3 base resistors can be anywhere from 5 ohms to 680 ohms for our typical larger Monopole Energizers. Other systems may require values outside of this range. Branch resistors are typically from 10 to 100 ohms. Both resistor can be from 1/2W to 5W (as shown above).
