4 DualPole Magnet Motor Double Stacked with 24 EMP coils

Your Price: $1,100.00

4 Pole Mini DualPolar Magnet Motor Double Stacked

10A 12VDC 4PDT Latching Relay Contactor for rotating batteries (+$40.00)

Variac (+$75.00)

Driver for Latching Contactor (+$15.00)

Send to:

or add name:

*We'll ask for shipping info at checkout

Quantity

Description
Customer Reviews

4 Pole DualPole Magnet Motor Double Stacked with 24 EMP Coils Assembled

The video below is the exact model. The third video was the prototype.

Click here for Single Stacked (1 Section) Model.

BATTERY ROTATING SCHEMATIC.

New: Driver board for Latching Contactor

This Energizer has the same motor and generator coils and rotors as the regular 4 DualPole double stack. The frame plates and rods are enlarged to support more coils and weight. There are 12 extra coils added to each layer as in the above video of the first prototype (4 on the inside and 8 on the outside).

Optional Autotransformer Variac for loading the generator coils

This is shown in our video. When the 4 (or 8 if you have a doublestacked motor) generator coils are in series you can connect the two wires to the variac. Use at your own risk. We can only recommend this to be done by qualified technicians and in accordance with local code requirements. When so connected the motor will speed up with a suitable load when the dial is turned down to 0-10V. As you turn it up it will slow down the motor more and more. If the switch is turned off the motor will slow down (if the dial was below 10V under load). This allows for another gain in the motor and also as a variable output. Do not turn dial while turned on (especially under heavy load) or it may arc.

You can also add more coils around the motor coils as shown in our video to increase the output without affecting the motor function and its regular gains. This is also shown in our above video. Click the link to add as many coils to your order as you wish. They are not a huge gain to the system, but they are significant.

As of April 9, 2018 controller boards come with optional battery rotating built into the code. To activate battery swapping code place jumber across pins 4 and 5 and use pins 3 and 6 to drive two mosfets to momentarily power alternating solinoids on a four pole latching contactor. See above video and schematic for details. Presently we offer the latching contactor. New: Driver for Latching Contactor.

Also optional upgrades as shown in the following video: HV Switching Inversion of Negative Energy to Positive for Battery

Options to upgrade previous models:

1200V 100A Mosfet

1200V high speed diode

SCR

HF 450V low ESR Capacitor