0 item(s) in cart/ total: $0
Custom Motor Coils, Spools, Parts
> Large heatsinks 11" wide x 14" long x 3 3/4" deep
Heatsink is cut to size ordered.
Large heatsinks 11" wide x 14" long x 3 3/4" deep
Drill and Tap
Drill and Tap for 10 boards 80 circuits [+$265.00]
Circuit board with 8 Circuits unassembled [+$80.00]
Circuit board with 8 Circuits assembled [+$110.00]
select name from list
other, add new name below
or add name:
*We'll ask for shipping info at checkout
Put me on the Waiting List
Add to Cart
Add to Wish List
This large heatsink can be used for 10 of our circuit boards that have 8 circuits each. Additional room (over 1") would be available on either side of the boards for additional sinking or surface area. Blades are 0.19" thick with 0.63 air gaps. Our circuit boards with the MJL21194 transistors do not need heatsinking if you are pushing 0.5 Amps each transistor. The L bracket heat sinks that come with the boards are fine to use up to 1 Amp each transistor. But if you want to push higher Amps then this sink is recommended. This sink will also be used with our boards with Mosfets in the future. These are 2500W devices and will fit in the same hole patters as used with our present boards. Drilling and tapping service also an option above for additional cost. That would be for 10 boards or 80 circuits. Circuit boards also available assembled or unassembled.
5 Small Spools used with SMALL Energizers.
1 Rotor with 8 magnets and hub 4 DualPole Sr.
6 oz R60 3 7/16 x 1/16" Welding Rods
Four (4) Wire Listed Grounding and Power lug with two (2) #10 in. mounting holes (4)2-14AWG wire holes
Tesla Coil Secondary 30awg 20" 1810 turns wound on 3.5 inch PVC (COPY)
Renaissance Resonance Induction Coupler Kit