Renaissance Energy Harvesting Meeting
Focused on Resonance, Grounding, Impulsing, and Nonlinear Engineering.
We are having two days (over 20 hours) of meetings in Elkhart Indiana (at a hotel) on October 29-30. There is no limited on the amount of people that can attend.
Resonance kits ordered with registration will be received at the meeting. We will be focusing on the new Resonance Induction Coupler Kit Part 2, Grounding and the new Renaissance Solar Charger Controller at this meeting.
Come learn about Don Smith Resonance Systems and about practical alternative energy solutions, as well as how to rejuvenate and keep batteries.
Watch as we demonstrate Tesla related technology, motors of various sizes powering lights, fans, generators, watercraft, etc., while charging batteries at around the same rate as the batteries powering the motors are discharging.
We have been doing these meetings all over the US and in Europe and Canada since 2010. Our goal is to teach the Free Energy principles so that you do not have to depend upon anyone else.
In the above video we show a clip from one of the last meetings where over 120 coils were powering LEDs from just 1W input. We showed 300 coils at the Orland meeting.
8:30-9:00 Welcome, Overview, Introduction
9-10:30 Battery charging
12-12:30 Circuit introduction
1:30-4 Workshop working with the Resonance Induction Coupler Kit
4:30-5 Finish kit
Day Two (Saturday Oct 30th):
8:30-10:00 Open Nonlinear Engineering
10:15-11:15 Demonstrations/Alternative Energy Demonstrations
- The Renaissance Charger Controller
- The Renaissance Resonance Induction Coupler Kit
- The Renaissance Resonance Induction Coupler Kit Part 2
- The New 8 Magnet 4 coil Window motor
- The New Fan kit with the full conversion not sold before
- The Large Resonance Induction Coupler Kit
- The Renaissance Chargers/Rejuvenators
- The DualPole Motor Energizers
- The Magnet Motor Energizers
- The Brushless Fan Energizers
- The Overunity Demonstrations
PREVIOUS MEETINGS AND DEMONSTRATIONS BELOW:
Shows the 4 DualPole running an industrial fan,12" motor with 10KW generator,
and 10 Coiler and mini 4 DualPole in self-running mode.
SELF-SUSTAINING MOTORS SHOWN AT CONVENTIONS
Last weekend (2016) we had the best Convention Workshop ever. It was a small meeting due to being the holiday season but it was enjoyed by all. The highlight of the meeting were two different motors running while their batteries were charging. That is, not only were the secondary output batteries charging, but the primary batteries powering the motor were also kept in a charging state as additional loads were placed on the output of the motor. We also gave the background information about what we were doing with the system. We started off the meeting showing the little mini magnet motor kit powering the mini DualPole kit, and then later the mini DualPole kit self-sustained while we added various LED loads on the output. Later we ran the 10 coiler DualPole kit with only 2 of the motor coils hooked up to circuits. 8 motor coils and 10 generator coils were not connected (due to lack of time) but placed a significant load on it. The motor was run at 24 volts and around 5-6 Amps. Three 9000 lumens 100W LEDs were powered and a stove top cooking element was heated on the front side of the circuit, while 24V of golf-cart batteries were being charged on the secondary side. When we added another 'open paths' process to the system everyone could see the three LEDs go to full brightness, the primary battery stop discharging, and two 11000 lumens LEDs go to full brightness (we had to cover them they were so bright). This demonstration ended up damaging one of my clamp ampere-meters due to the very amplified negative energy intensity. We also showed how the industrial 12” magnet motor can power a 10KW generator while charging batteries. Also shown was the larger 4 DualPole motor running a large industrial fan at variable speeds with our water-cooled mosfet controller. The setup represented a forced air heating or cooling and lighting system. We powered 4 100W LEDs very brightly with the generator coils at the same time. The motor was run on 24V of 35AH batteries up to 50A and charged two more of the same batteries at the same time.
Renaissance Charge, LLC.
ATTENTION: THIS IS NOT A STORY-TELLING EVENT BUT A LIVE DEMONSTRATION OF OVERUNITY SYSTEMS. TIME WILL BE GIVEN TO ANSWER YOUR PRACTICAL APPLICATION QUESTIONS. DON'T MISS THIS MEETING.
- To learn about cutting edge technology that is changing the world.
- To meet other like-minded people and make personal and business connections.
- To participate in workshops where we build these systems together the right way.
- To have good times and to be amazed!
Chicago March 2015 Meeting
The Ten Coiler DualPole Motor in the new configuration.
Presenting the Renaissance Charger collection.
Going over the details about battery charging.
Which box are you in?
Explaining the operation of the 10 Dualpole Motor.
Contact us at [email protected] to arrange to bring your batteries to be used and/or rejuvenated during the meetings.
Renaissance Porsche shown in CDA Idaho 2011
Renaissance Boat demonstrated in CDA IDAHO 2011