This coil can to be used with the Resonance Induction Coupler Kits 1 and 2 and is the exact same wire length as the kit 1 coil. It is built with 3D print using PETG material where there are grooves to hold the wire in place. The spacing between the wires allows for high voltage. The wire gauge is #19.
Comes with one 20kV capacitor to be used in series or parallel, and brass bolts, washers and nuts. See below picture of example of the parts with clear color (we are making white and blue spools). The center one is the primary running off only the very low power frequency generator.
In the picture below two identical coils on either side are powering 5W LEDs at partial brightness (bulbs not included in the purchase of this coil).
This was first displayed at the October 2023 Convention.